ChoiceQuill is reader-supported. When you buy through links on this page, we may earn a commission. You pay the same price either way.
Switch sound test videos keep pairing one name with boutique options at several times the price. That name is the Leobog GrayWood V4.
YMDK sells it for under $8 for a small pack. We read the product listing, looked at an independent switch review, and checked how the sound test community describes it.
The goal was simple: find out whether the hype is earned.
The Spec Sheet at a Glance
The GrayWood V4 is a 5-pin linear switch made from POM (polyoxymethylene). Among keyboard fans, this plastic is known for a deeper tone with less scratch than the polycarbonate housings found on most switches.
YMDK’s listing gives an operating force of 40gf and a bottom-out force of 50gf. Both come with a tolerance of about 3 grams. Total travel is 3.6mm.
Pre-Lubed Straight From the Factory
Every switch ships lubed. That counts for a lot on a budget part, since many inexpensive linears show up dry and rough until an owner lubes them by hand.
The V4 revision also brings a better light guide column and two shaft feet. These small tweaks aim to reduce stem wobble, a frequent complaint about low-cost linears.
Pricing and Stock
YMDK sells the switch in bundles of 10 up to 110 pieces. Prices start at $7.99, depending on the quantity.
Right now, every quantity option shows as sold out on YMDK’s own listing. Their switch runs sell out often.
The button below opens the live listing, so you can check stock or catch the next restock.
What an Independent Review Found
The review site Click and Thock ran the V4 through its standard test suite. Smoothness earned an 8 out of 10, a solid mark for a switch at this level of pricing.
Their gear recorded noise of around 80 decibels. They also listed a PA12 stem sitting in a housing that blends PC and PA66.
Like YMDK’s listing, they confirmed the switch comes pre-lubed from the factory.
How the Switch Sounds
Sound tests and comparison clips from the switch community tell a consistent story. The tone is deep and “thocky”, with some scratch texture underneath.
Top-shelf POM switches that cost many times more sound smoother and more muted. That scratchy edge is what separates the V4 from high-end boutique linears.
It is the trade-off you accept at this price.
Strengths Worth Noting
- Sound for the money. Few switches deliver this much depth for under $8 a pack. Most with a similar sound profile carry a noticeably higher price.
- Factory lube. Install them in a hot-swap board and the feel is already fairly smooth. You skip the extra purchase of lube and a switch opener.
- Stability upgrades. Two shaft feet and the improved light guide column target the wobble that budget linears often get criticized for.
Drawbacks to Weigh
The scratchy undertone is the clearest limitation. If you want a perfectly clean, boutique-level thock, this is not that switch.
Reviewers agree on that point.
It is also a budget part. Inexpensive linears tend to vary more from one pack to the next than premium ones do.
With 70 or 110 pieces in your hands, expect the odd outlier instead of flawless uniformity.
Stock is the other real caveat. YMDK produces these in limited batches, so finding the V4 available takes patience or lucky timing.
If it is sold out when you look, YMDK’s other switch brands are worth browsing while you wait. Gateron and TTC are two examples.
Who Should Pick It Up
This switch suits anyone building or upgrading a hot-swap board who wants a deep, satisfying thock without boutique pricing. The factory lube makes it an even smarter buy.
If zero scratch is your top priority, save your money for a premium POM linear. Think of the V4 as a very good budget alternative, not a direct substitute.